Skip to content

How to Jumpstart a Toyota Corolla

If your Toyota Corolla has been sitting for a while, you may need to jumpstart it. Here’s how: 1. Make sure the battery is fully charged.

If it’s not, charge it for at least 24 hours before proceeding. 2. Connect the positive (red) terminal of the battery to the positive terminal of the starter motor. 3. Connect the negative (black) terminal of the battery to a metal ground on the engine block away from any moving parts.

4. Have someone turn the key in the ignition while you hold down the accelerator pedal all the way to floorboard.

  • First, open the hood of your Corolla and locate the battery
  • Once you’ve found the battery, use a wrench or pliers to loosen the negative terminal clamp, then remove it from the battery post
  • Do the same with the positive terminal clamp, being careful not to touch any metal parts of the car with the wrench or pliers while they’re still connected to the live battery terminals
  • Now that both clamps are removed, use a wire brush or some other type of cleaning tool to clean off any corrosion that has built up on the terminal posts
  • Take your time doing this so that you don’t accidentally drop anything into the engine bay while you’re working
  • Once the terminals are clean, reattach the negative clamp first, followed by the positive clamp
  • Tighten each one down securely with your wrench or pliers before moving on
  • Now go to your driver’s seat and insert your key into ignition , but don’t turn it just yet
  • 9 Press and hold down on boththe accelerator pedal and brake pedal atthe same time for about 30 seconds
  • 10 This will help primethe fuel system inyour Corollaso that it’ll start more easily whenyou finally do turnthe key
See also  2008 Toyota Yaris Rear Bumper Removal
How to Jumpstart a Toyota Corolla

Credit: www.toyotaofsantafe.com

How Do I Jumpstart My Toyota Corolla

Assuming you would like tips on jump starting your Toyota Corolla: If your car has a manual transmission, ensure that it is in neutral before beginning. If your car has an automatic transmission, make sure it is in park.

Turn off all electronics in the car, including the radio and any lights. Open the hood of both cars and locate the battery. The positive terminal will have a red cap (or be marked with a “+” sign), while the negative terminal will have a black cap (or be marked with a “-” sign).

Attach the red jumper cable to the positive terminal of your dead battery. Then attach the other end of the red jumper cable to the positive terminal of the good battery. Next, attach one end of the black jumper cable to the negative terminal of the good battery.

Finally, attach the remaining black jumper cable to an unpainted metal surface under your Corolla’s hood—this will help ground your jump-start attempt and prevent sparks near batteries (which could cause fires). Start up your helper vehicle and let it idle for five minutes or so; then try starting up your Corolla.

Conclusion

If your Toyota Corolla has been sitting for a while, you may need to jumpstart it. Here’s how: 1. Make sure the battery is fully charged.

If not, charge it for at least six hours before attempting to jumpstart the car. 2. Connect the positive (red) cable to the positive terminal on the battery, and connect the negative (black) cable to a solid metal ground on the car. Do not connect the negative cable to anything else on the car, as this could damage sensitive electronic components.

See also  Egr Valve for Toyota Corolla


3. Have another person start their car and let it run for a few minutes. Then try starting your Toyota Corolla.

Leave a Reply

Your email address will not be published. Required fields are marked *