Skip to content

Prius Will Not Go into Ready Mode

The Toyota Prius is a hybrid car that uses both an electric motor and a gasoline engine. The electric motor is used to power the car at low speeds, while the gasoline engine is used when more power is needed. One of the features of the Prius is that it will go into “Ready Mode” when it’s turned off, which means that the electric motor will be ready to power the car when it’s turned back on.

However, there have been reports of people not being able to get their Priuses into Ready Mode, which means they have to use the gasoline engine to start the car. This can be frustrating, especially if you’re trying to save money on gas. There are a few possible reasons why your Prius might not be going into Ready Mode.

There are a few things that can prevent your Prius from entering Ready mode. One possibility is that the 12-volt battery may be low. The Prius requires a strong 12-volt battery to enter Ready mode.

Another possibility is that there may be an issue with the hybrid system itself. If you take your Prius to a dealer or qualified mechanic, they should be able to diagnose and fix the problem.

Prius Will Not Go into Ready Mode


How Do I Put My Prius in Ready Mode?

Assuming you are talking about the 2010 model year and newer, to put your Prius in READY mode: 1. Make sure the power switch is in the “ON” position. 2. Press and hold the brake pedal down.

3. While holding down the brake pedal, press the START button once (do not hold). The engine should start and then stop after a few seconds. If it doesn’t start, make sure you’re pressing and releasing the START button correctly – it can be tricky!

See also  2007 Rav4 Battery Replacement

4. Once the engine has stopped, release the brake pedal and you’re ready to go!

Why Does My Prius Dashboard Say Ready?

When you first get in your Prius and turn on the power, the “Ready” message appears on the dash. This means that the car is ready to go! The message goes away after a few seconds, but it’s there to remind you that everything is working properly and the car is ready to drive.

How Do You Force Restart a Prius?

If you need to force restart a Prius, there are a few ways to do it. One way is to hold down the power button for about 10 seconds. This should trigger a full reboot of the system.

If that doesn’t work, you can try opening and closing the door three times in quick succession. This should also force a restart. Finally, if all else fails, you can disconnect and reconnect the battery terminals.

Why Does My Prius Turn on But Not Start?

If your Prius turns on but won’t start, it could be for a variety of reasons. Here are some potential causes and solutions: 1. The battery may be dead or low on power.

Try charging the battery overnight with a trickle charger. If that doesn’t work, you may need to replace the battery. 2. There could be an issue with the starter motor or starter solenoid.

You can try tapping on the starter motor with a hammer to see if it will engage (this sometimes works). If not, you’ll need to have a mechanic check it out.

See also  What is a Efi Fuse
3. It’s also possible that there is a problem with the fuel system, preventing fuel from reaching the engine.

This is less common, but if you suspect this might be the case, take your car to a mechanic to have it checked out.

TUTORIAL – Help! My Prius won't go into gear. Won't go into drive mode. It won't move!

Prius Ready Mode

When you’re ready to depart, set the Toyota Prius into Ready mode. This is done by depressing the power button for two seconds until you see and feel the vehicle chime. The message “READY” will appear on the multi-information display in the instrument panel, letting you know that all systems are go.

All doors will be locked and the headlight system will automatically turn off. The engine will also stop running when in Ready mode, which conserves fuel and reduces emissions while you wait.


The Toyota Prius is a hybrid vehicle that has been having issues with the “Ready” mode. This mode is necessary in order to drive the car. The problem seems to be with the electric motor and battery system not working together correctly.

Toyota is aware of the problem and is currently working on a fix. In the meantime, they are advising drivers to use the “PWR” mode instead of “Ready”.

Leave a Reply

Your email address will not be published. Required fields are marked *